6vacon • 74 Control KeypadTel. +358 (0) 201 2121 • Fax +358 (0)201 212 2056.2 Keypad push-buttonsThe Vacon NX alphanumeric control keypad has 9 push-buttons that are used for controllingVacon ® NX Active Front End, setting parameters, and monitoring values.Figure 53. Keypad push-buttons6.2.1 Buttons descriptions= This button is used to reset active faults. See Chapter 6.3.4.= This button is used to switch between the two latest displays. This may be usefulwhen you want to see how the changed new value influences some other value.=The enter button is used for:1) confirmation of selections.2) fault history reset (2…3 seconds).=Browser button up.Browse the main menu and the pages of different submenus.Edit values.=Browser button down.Browse the main menu and the pages of different submenus.Edit values.=Menu button leftMove backward in menu.Move cursor left (in parameter menu).Exit edit mode.=Menu button rightMove forward in menu.Move cursor right (in parameter menu).Enter edit mode.=Start buttonPressing this button starts Vacon NX Active Front End (modulation) if the keypadis the active control place. See Chapter 6.3.3.=Stop buttonPressing this button stops Vacon NX Active Front End (unless disabled byparameter R3.4/R3.6). See Chapter 6.3.3.enterresetsele ct11208.emfresetselectenter+-