Vaillant geoTHERM VWS Installation Instructions Manual

Also see for geoTHERM VWS: Installation instructions Operating manual Operating manual

Contents

Vaillant geoTHERM VWS Installation Instructions Manual Manual pdf 16 page image

Installation instructions geoTHERM VWS 0020046310_0116Pos. Description1 1 Heat pump2 1 Operating console, pillar cover3 3232Gaskets (yellow/green) for heating circuit elbowunionsM6 flat-headed screws for fitting the operatingconsole to the frame (plus one spare screw)Self-tapping screws for the operating consoleframe (incl. one spare screw)Self-tapping screws for fastening thevrnetDIALOG unit4 1 6 Litre brine expansion tank incl. brass adapter,max. 3 bar5 1 VRC-DCF outside temperature sensor6 4 VR 10 sensors7 1 Control cable for vrnetDIALOG8 5 45° connection elbow with cap nuts9 1 Expansion relief valve for brine circuit, 1/2", 3 bar10 1 Bag of small parts for fastening the brineexpansion tank11 1 Clamp for fastening the brine expansion tank12 1 Insulation matting for heat source connection onthe rear wall13 5 Installation instructions, operating manual14 2 Seals with metal support rings for heat sourcecircuit connection elbowsTable 4.2 Scope of deliveryThe frame for the operating console is already fastenedto the heat pump casing on delivery.4.8 Unpacking the unit and checking the delivery2 xFig. 4.5 Removing the transport securing device• Carefully remove the packaging and padding, takingcare not to damage any parts of the unit.• Unfasten the transport securing devices (brackets)with which the heat pump is fixed to the pallet.The brackets are no longer required.4.9 Transporting the heat pumpWe recommend that the heat pump be transported withthe aid of a suitable barrow. The handles on the rearside of the unit are provided as transportation aids (seeFig. 2.5, Item. 4).d Danger!Risk of injury!Depending on type, the heat pumpweighs 140 - 195 kg in the unfilled state.To avoid injury, use several people to liftit.a Caution!Risk of damage!Regardless of the mode of transport, theheat pump must never be tilted by morethan 45°. Otherwise it can cause mal-functions in the coolant circuit duringlater operation, which in the worst casecan lead to a failure of the whole sy-stem.max. 45°Fig. 4.6 Transporting the heat pump (carrying)4 Assembly and installation