INSTALLER GUIDEPage 172. The flue must conform to BS 5440: Part 1 in design and installation.The flue, measured from the bottom of the fireplace opening to the bottom of theterminal, shall be not less than 3m in actual vertical height. When calculated inaccordance with BS 5440: Part 1 Annex A, the minimum equivalent height of the flueshall be 2.0m of 125mm dia. flue pipe.3. The flue must not be used for any other appliance or application.4. Proprietary terminals must comply with BS 715 or BS 1289. Any terminal ortermination must be positioned in accordance with BS 5440 Part 1 to ensure that theproducts of combustion can be safely dispersed into the outside atmosphere. Wherethe appliance is connected to an unlined brick chimney it is generally unnecessary forthe chimney pot to be replaced or for a terminal to be fitted unless the flue has adiameter smaller than 170mm.4. PACK CONTENTSThe items required for this appliance are packed in sections.Section 1 - Fire unit contains:1 Burner and convection box unit.1 Burner tray trim (Homeflame Dream and Homeflame Petrus only).1 Outlet baffle for the convected air outlet (Homeflame Dream only).2 Tapping Screws for outlet baffle (Homeflame Dream only).1 Nut and olive for 8mm inlet pipe.1 ‘T’ connector and pressure test point.1 Flue restrictor.3 Tapping Screws (For flue restrictor).2 Small “U” seals (For convection box side flanges).2 Strips of floor sealing tape.6 Fibre / wooden plugs.4 Woodscrews.2 Fire retaining cables.2 Cable clamps.4 Eyebolts.1 Rubber grommet (For rear of convector box).2 Machine screws (For fascia hanging).2 Washers for fascia hanging (Homeflame Dream and Homeflame Petrus only)1 PP3 Battery.1 Smoke match tube.2 Fireback spacing brackets.4 Tapping Screws (For fireback spacing brackets).2 Lengths of self adhesive foam seal.1 Literature pack (Not shown).1 Ceramic fuel effect set (Not shown).© Baxi Heating U.K. Limited 2009.