Valor Fires 961 Homeflame Dream Installation And Owner's Manual

Contents

Valor Fires 961 Homeflame Dream Installation And Owner's Manual Manual pdf 40 page image

INSTALLER GUIDEPage 405. Refit in the reverse order. Make sure that the fascia is properly located over theupper retaining brackets. See section 14 of this guide for detailed fitting instructions.16.4.2 Homeflame Harmony model.1. Carefully lift the fascia upward and forward.2. Place the fascia in a safe place away from the gas fire.3. To fit the fascia, place the top of the fascia againstthe fireplace front surface so that the two retainingplates at the back of the fascia are directly above thetwo retaining brackets on the convector box. Keepingthe lower part of the fascia clear of the ceramic fueleffect, lower the fascia making sure that the rearretaining plates locate fully into the retaining bracketson the convection box (See figure 35). The fasciabottom is held in place with magnets. These should belocated as in figure 35.16.5 To replace the control slide unit.1. Remove the fascia (See section 16.4).2. Remove the knurled screw securing the controllinking arm to the burner (See figure 41).3. Detach the slide unit by removing two screws securing itto the convection box flange (See figure 42).4. Replace in the reverse order.16.6 To replace the control slide button.1. Remove the fascia (See section 16.4).2. Unscrew and remove the two screws securing the slidebutton to the slider mechanism.3. Remove the button, replace and fit in the reverse order.© Baxi Heating U.K. Limited 2009.Figure 42. Slidermechanism removalFigure 41. Control linkagedisconnection