140 LightingDoor-to-door light functionDipped beam and reversing lights 3 lightfor around 30 seconds after the driver exitsthe vehicle and closes his door.To activate1. Switch off ignition.2. Remove ignition key. 3.3. Open driver’s door.4. Pull turn signal stalk toward steeringwheel.5. Close driver’s door.If the driver’s door is left open, the lights willgo out after two minutes.Door-to-door lighting can be deactivatedby inserting the key in the starter switch orby pulling the turn signal stalk toward thesteering wheel again while the driver’s dooris open.Parking lights 3The front parking light and tail light of oneside of the vehicle can be activated whenparking:1. Set light switch to 7 or AUTO 3,2. Ignition off3. Move turn signal stalk all the way up(right parking light) or down (left parkinglight).An acoustic signal sounds and controlindicator O illuminates briefly in theinstrument panel to indicate activation.To switch it off, switch on the ignition ormove the turn signal stalk in the oppositedirection.Instrument illumination ,Information display illuminationComes on when ignition is switched on.Brightness can be adjusted when theexterior lights are on: Push to release knobk and then turn it clockwise oranticlockwise and hold until the desiredbrightness is obtained.Display mode 3 – page 58.
