6 Set up with the indicating and adjustmentmodule PLICSCOM6.1 Short descriptionThe indicating and adjustment module is used for measured valuedisplay, adjustment and diagnosis. It can be mounted in the followinghousing versions and instruments:l All sensors of the plics® instrument family, in the single as well asin the double chamber housing (optionally in the electronics orconnection compartment)l External indicating and adjustment unit VEGADIS 61From a hardware version …- 01 or higher of PLICSCOM as well as ahardware version …- 01, 03 or higher of the corresponding sensor, anintegrated backlight can be switched on via the adjustment menu. Thehardware version is stated on the type label of the PLICSCOM or thesensor electronics.Note:You can find detailed information on adjustment in the operatinginstructions manual "Indicating and adjustment module".6.2 Insert indicating and adjustment moduleThe indicating and adjustment module can be inserted into the sensorand removed again at any time. It is not necessary to interrupt thepower supply.Proceed as follows:1 Unscrew the housing cover2 Place the indicating and adjustment module in the desired positionon the electronics (you can choose any one of four differentpositions - each displaced by 90°)3 Press the indicating and adjustment module onto the electronicsand turn it to the right until it snaps in.4 Screw housing cover with inspection window tightly back onRemoval is carried out in reverse order.The indicating and adjustment module is powered by the sensor, anadditional connection is not necessary.Function/ConfigurationMount/Dismount indicat-ing and adjustmentmodule24 VEGACAL 62 • Profibus PA6 Set up with the indicating and adjustment module PLICSCOM30025-EN-090603