Vega VEGAPULS 62 standpipeversion Operating Instructions Manual
                                                                            | |
Contents
| 
5.2 ConnectThe voltage supply and signal output are connected via the spring-loaded terminals in the housing.The connection to the indicating and adjustment module or to theinterface adapter is carried out via contact pins in the housing.Proceed as follows:1 Unscrew the housing cover2 If an indicating and adjustment module is installed, remove it byturning it slightly to the left.3 Loosen compression nut of the cable entry4 Remove approx. 10 cm (4 in) of the cable mantle, strip approx.1 cm (0.4 in) of insulation from the ends of the individual wires5 Insert the cable into the sensor through the cable entryFig. 2: Connection steps 5 and 66 Insert the wire ends into the terminals according to the wiring planInformation:Solid cores as well as flexible cores with cable end sleeves areinserted directly into the terminal openings. In case of flexible coreswithout end sleeves, press the terminal head with a small screwdriver;the terminal opening is freed. When the screwdriver is released, theterminal closes again.7 Check the hold of the wires in the terminals by lightly pulling onthem8 Connect the screen to the internal ground terminal, connect theouter ground terminal to potential equalisationConnection technologyConnection procedure14 VEGAPULS 62 standpipe version • Foundation Fieldbus5 Connecting to the bus system36510-EN-120301 |
Related manuals for Vega VEGAPULS 62 standpipeversion
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine