386 Set up the sensor with the display and adjustment moduleVEGAPULS 69 • Modbus and Levelmaster protocol47252-EN-18062712453Fig. 34: Display and adjustment elements - with adjustment via magnetic pen1 LC display2 Magnetic pen3 Adjustment keys4 Bluetooth symbol5 Lid with inspection windowWhen the [+] and [->] keys are pressed quickly, the edited value,or the cursor, changes one value or position at a time. If the key ispressed longer than 1 s, the value or position changes continuously.When the [OK] and [ESC] keys are pressed simultaneously for morethan 5 s, the display returns to the main menu. The menu language isthen switched over to "English".Approx. 60 minutes after the last pressing of a key, an automatic resetto measured value indication is triggered. Any values not confirmedwith [OK] will not be saved.6.4 Measured value indication - Selection ofnational languageWith the [->] key you move between three different indication modes.In the first view, the selected measured value is displayed in largedigits.In the second view, the selected measured value and a correspond-ing bar graph presentation are displayed.In the third view, the selected measured value as well as a second se-lectable value, e.g. the temperature of the electronics, are displayed.During the initial setup of an instrument shipped with factory settings,use the "OK" key to get to the menu "National language".This menu item is used to select the national language for further pa-rameter adjustment. You can change the selection via the menu item"Setup - Display, Menu language".Time functionsMeasured value indica-tionSelection of nationallanguage