Chapter 3 — The Video Playback Controller 163Dynamic Settings Window: Default(Figure 3-17) Click on Dynamic Settings from the Playback Controller bar todisplay and change the following playback parameters:Blank Video Button – Video is muted while audio playback continues.Playback (Freeze on Stop) – Stops video playback immediately and freezesframe of last image.Routing – Set output selection for the two outputs (primary and secondary) fromsix possible sources.Video Switch – Sets when to fade or switch video source. Video switchingrequires both channels to be genlocked to the same genlock source.Fade Time – Sets amount of time to fade between clip switching.Swap L/R Channels – When checked, the left and right channels are swapped.Audio Section – Selects the primary and secondary audio sources (see listingon following page):Figure 3-17.Dynamic Settings Window (Default View)