488. Swiveling the milling headIn order to create bored holes or contact areas under an angle that deviates from the usual vertical po-sition of the milling head, the milling head may be swiveled up to 90 degrees to the left or right.To swivel the milling head, proceed as follows:1. Undo the hexagonal nut (6) clockwise against the tool spindle housing far enough that the index bolt(4) can be removed by hand.2. Slightly undo the hexagonal screw (19) and the hexagonal (21) on the vertical slide by rotating an-ti-clockwise.3. Swivel the milling head to the left or right to the desired degree position4. To secure the milling head in the desired position, tighten the hexagonal screw (19) and hexagonalnut (21)Bringing the milling head back to the normal position1. Undo the hexagonal screw (19) and the hexagonal nut (21) on the vertical slide in such a way thatthe milling head can be swiveled.2. Bring the milling head back to the vertical position3. After returning the hexagonal nut (6) back into place on the index bolt, this may be pushed into theopening on the tool spindle housing by hand and secured with light hammer blows.4. Tighten the hexagonal nut (6) and the securing nut (7) of the index bolt (4) as well as the hexagonalscrew (19) and the hexagonal nut (21) on the vertical slide.4671921
