WAGNER 0558001 ProSpray 3.23 Operating Manual

26 ProSpray 3.23GBDescription of unit Starting operation3.5 Technical dataVoltage: 220-240 Volt , 50/60 HzMax. current consumption: 6.0 APower cord: 3 x 1.5 mm2 – 6 mAcceptance capacity: 1035 WattMax. operating pressure: 221 bar (22.1 MPa)Volume flow at 12 MPa(120 bar) with water: 2.3 l/minMax tip size: 0.024 inch – 0.61 mmMax. temperature of thecoating material: 43°CMax viscosity: 20.000 mPa·sWeight: 17.7 kgSpecial high-pressure hose: DN 6 mm, 15 m, connectionthread M 16 x 1.5Dimensions (L X W X H): 436 x 369 x 416 mmMax sound pressure level: 80 dB (A) ** Place of measuring: 1 m in distance from the unit and 1.6m above the floor, 12 MPa (120 bar) operating pressure,reverberant floor.3.6 Transportation in vehicleSecure the unit with a suitable fastening.4. Starting operation4.1 High-pressure hose, spray gun andseparating oil1. Screw the pressure gauge (1) to the coating materialoutlet (Fig. 2, Item 2).2. Screw the high-pressure hose (3) to the coating materialoutlet on the pressure gauge (Fig. 2, Item 4).3. Screw the spray gun (5) with the selected tip onto thehigh-pressure hose.4. Tighten the union nuts at the high-pressure hoses firmlyso that coating material does not leak.514235. Remove the oil cup cap with a straight-slot screwdriver.6. Fill the oil cup with EasyGlide (Fig. 3) until the oil gauge(6) is showing that it is full.AttentionEasyGlide prevents increased wear and tear tothe packings.7. Replace oil cup cap.8. Press oil button 2-5 times to prime the oiler. Press oncefor every eight hours of usage to lubricate the fluid section.9. Fully depress the pusher stem to make sure the inlet ballis free.