WAGNER GM 4700AC Original Operating Manual

Also see for GM 4700AC: Operating manual Translation of the original operating manual

Contents

WAGNER GM 4700AC Original Operating Manual Manual pdf 13 page image

134.2.2 SAFE HANDLING OF WAGNER SPRAY DEVICESHazard due to injection of lacquer or flushing agent into the skin!The spray jet is under pressure and can cause dangerous injuries. Avoid injection oflacquer or flushing agents:Never point the spray gun at people.Never reach into the spray jet.Before any work on the device, in the event of work interruptions and malfunctions:– Switch off the energy/compressed air supply.– Relieve the pressure from the spray gun and device.– Secure the spray gun against actuation.– Disconnect the control unit from the mains.– In the event of functional faults: remedy the fault as described in the"Troubleshooting" chapter.If necessary or at least every 12 months, the liquid ejection devices must bechecked for safe working conditions by an expert (e.g. WAGNER Service Technician)in accordance with the guidelines for liquid ejection devices (ZH 1/406 and DGUV100-500 Chapters 2.29 and 2.36).– For shut down devices, the examination can be suspended until the next start-up.In the event of skin injuries caused by lacquer or flushing agents:Note the lacquer or flushing agent that you have been using.Consult a doctor immediately.Danger due to recoil forces!Actuating the trigger can causes strong recoil forces. Thereby, the user can lose hisbalance and injure himself when falling.Avoid risk of injury from recoil forces:Ensure that you have firm footing when operating the spray gun.4.2.3 GROUNDING THE UNITHazard due to electrostatic charge!Explosion hazard and damage to the device.Friction, flowing liquids and air or electrostatic coating processes create charges. Flamesor sparks can form during discharge.Correct grounding of the entire spraying system prevents electrostatic charges.Ensure that all devices and tanks are grounded before each spraying process.Ground the work pieces to be coated.Ensure that all persons inside the working area are grounded, e.g., that they arewearing static dissipative shoes.Wear static dissipative gloves when spraying. The grounding takes place via thespray gun handle or the trigger.VERSION 06/2018 ORDER NUMBER DOC2311730