20GM 5000EAC."?B_00020OPERATING MANUALEDITION 03/2012 PART NUMBER DOC 23191504.5 SPRAYING PROCESS4.5.1 AIRCOAT ROUND JET SPRAY PROCESSIn the AirCoat process, high pressure of 3-15 MPa; 30-150 bar; 435-2176 psi is used to atomize the material.The air at 0-0.25 MPa; 0-2.5 bar; 0-36 psi produces a soft jet. The size of the spray jet can be adjusted by turningthe nozzle nut.AirCoat airMulti-channelswirl nozzleSpray jetNozzle nutSpray materialAirCoat airAdvantages• High painting capacity• Low fogging tendency• Good finish• High viscosity paints can easily be applied• High endurance of the nozzles• Change in width the jet4.5.2. AIRCOAT ATOMIZING FLAT JET SPRAY PROCESSIn the AirCoat process, high pressure of 3-15 MPa; 30-150 bar; 435-2176 psi is used to atomize the material.The AirCoat air at 0-0.25 MPa; 0-2.5 bar; 0-36 psi produces a soft jet, which largely eliminates the problem ofoverlapping boundaries. There´s a possibility to reduce the jet by form air.Shaping airAir capVariable sprayjet width Atomizing airAdvantages• High painting capacity• Low fogging tendency• Good finish• High viscosity paints can easily be applied• High endurance of the AC-nozzles• Change in width the jet