WAGNER PEM-X1 Original Operating Manual

Also see for PEM-X1: Operating manual Translation of the original operating manual

Contents

43PEM-X1Y XP_016763.1.2.OPERATING MANUALVERSION 09/2012 ORDER NUMBER DOC 2326020Procedure:1. Guide protective wedge 2 into wedge tool 1.2. Insert both parts into opening on electrodeholder until they stop.If it is not possible to push the wedge tool inas far as the mark X, rotate the wedge tool alittle until it can be pushed up to the mark.The mark X must be flush with the end Y ofthe electrode holder.3. The protective wedge is now correctlyassembled and the wedge tool can beretracted out of the electrode holder.4. The protective wedge remains inserted in theelectrode holder.Prior to re-fitting, check whether the contactpoints on electrode holder 3 and in gunhousing 5 have been thoroughly cleaned sothat the electrode tip is electrically connectedto the high-voltage generator.5. Fit fl at or round spray nozzle with thecorresponding electrode holder.Note:The same wedge tool is used to insert the protective wedge.