WAGNER PROSPRAY 20 Owner's Manual

Also see for PROSPRAY 20: Service manual Owner's manual

4SAFETY PRECAUTIONS ProSpray 20broken or damaged so that as to impair the functionof the power tool. Have damaged parts repaired beforeusing the power tool. Many accidents have their origin inpower tools that have been maintained badly.f) Use the power tool, accessories, insert tools, etc. inaccordance with these instructions and in a fashionspecified for this special tool type. Take the workingconditions and the activity to be carried out intoconsideration. The use of power tools for purposes otherthan the intended ones can lead to dangerous situations.g) Keep the handles and grip surfaces dry, clean and free ofoil and grease. Slippery handles and grip surfaces hampersafe operation and control of the electric tool in unforeseensituations.5. Servicea) Only have your power tool repaired by a qualifiedspecialist and only use original spare parts. Thisensures that the tool safety is maintained.b) If the supply cord is damaged, it must be replaced bythe manufacturer or it’s service agent or a similarlyqualified person in order to avoid a safety hazard.2 SAFETY REGULATIONS FORAIRLESS SPRAYINGAll local safety regulations in force must be observed.The following safety regulations are to be observed in order toensure safe handling of the Airless high-pressure spraying unit.2.1 FLASH POINTOnly spray coating materials with a flash pointof 21 °C or higher.The flash point is the lowest temperature atwhich vapors develop from the coating mate-rial. These vapors are sufficient to form an in-flammable mixture over the air above the coat-ing material.2.2 EXPLOSION PROTECTIONDo not use the unit in work places which arecovered by the explosion protection regula-tions. The unit is not designed to be explosionprotected. Do not operate the device in explo-sive areas (zone 0, 1 and 2). Explosive areas are,for example, places where paints are storedand locations in direct proximity to the objectbeing sprayed. Keep the device at least 3 mfrom the object you are spraying.2.3 DANGER OF EXPLOSION AND FIRE FROMSOURCES OF IGNITION DURING SPRAYINGWORKThere must be no sources of ignition such as,for example, open fires, lit cigarettes, cigars ortobacco pipes, sparks, glowing wires, hot sur-faces, etc. in the vicinity.2.4 DANGER OF INJURY FROM THE SPRAY JETAttention, danger of injury by injection!Never point the spray gun at yourself, otherpersons or animals.Only use the spray gun with spray jet touchprotection.The spray jet must not come into contactwith any part of the body.In working with Airless spray guns, the highspray pressures arising can cause very dan-gerous injuries. If contact is made with thespray jet, coating material can be injectedinto the skin. Do not treat a spray injury as aharmless cut. In case of injury to the skin bycoating material or solvents, consult a doctorfor quick and correct treatment. Inform thedoctor about the coating material or solventused.2.5 SECURE SPRAY GUN AGAINST UNINTENDEDOPERATIONAlways secure the spray gun when mounting or dismountingthe tip and in case of interruption to work.2.6 RECOIL OF SPRAY GUNWhen using a high operating pressure, pull-ing the trigger guard can effect a recoil forceup to 15 N.If you are not prepared for this, your hand canbe thrust backwards or your balance lost. Thiscan lead to injury.2.7 BREATHING EQUIPMENT AS PROTECTIONAGAINST SOLVENT VAPORSWear breathing equipment during spraying work.