WAGNER ProSpray 3.29 Owner's Manual

Also see for ProSpray 3.29: Operating manual Owner's manual Original operating manual Operating manual

48handling the high -pressure hOse / interruptiOn Of wOrk PS 3.29 / 3.316 HANdLING THe HIGH-PReSSuRe HoSei The unit is equipped with a high-pressure hosespecially suited for piston pumps.Danger of injury through leaking high-pressurehose. Replace any damaged high-pressure hoseimmediately.Never repair defective high-pressure hosesyourself!The high-pressure hose is to be handled with care. Avoid sharpbends and folds: the smallest bending radius is about 8” (20 cm).Do not drive over the high-pressure hose. Protect against sharpobjects and edges.Never pull on the high-pressure hose to move the device.Make sure that the high-pressure hose cannot twist. This can beavoided by using a Wagner spray gun with a swivel joint and ahose system.i When using the high-pressure hose whileworking on scaffolding, it is best to always guidethe hose along the outside of the scaffolding.i The risk of damage rises with the age of the high-pressure hose. Wagner recommends replacinghigh-pressure hoses after 6 years.i Use only Wagner original-high-pressure hosesin order to ensure functionality, safety anddurability.7 INTeRRuPTIoN oF WoRK1. Open the relief valve, valve position PRIME (k circulation).2. Switch the unit OFF.3. Turn the pressure control knob counterclockwise tominimum pressure.4. Pull the trigger of the spray gun in order to release thepressure from the high-pressure hose and spray gun.5. Secure the spray gun, refer to the operating manual of thespray gun.6. If a standard tip is to be cleaned, see Page 57, Section 12.2.If a non-standard tip is installed, proceed according to therelevant operating manual.7. Depending on the model, leave the suction tube or thesuction hose and return hose immersed in the coatingmaterial or swivel or immerse it into a correspondingcleaning agent.AttentionIf fast-drying or two-component coating materialis used, ensure that the unit is rinsed with asuitable cleaning agent within the processingtime.