70 Commissioning WAGO-I/O-SYSTEM 750750-493 3-Phase Power Measurement ModuleManualVersion 1.2.0Pos : 92 /All e Seri en (Allgemei ne Module)/Ü berschriften für alle Serien/__ noc h nic ht ei ns ortierte Ü berschriften müss en noc h eins orti ert werden __/Anzeigen der Mes s werte mit WAGO-I/O-CHEC K - Ü berschrift 2 @ 13\mod_1355494395030_21.doc x @ 107680 @ 2 @ 18.2 Displaying the Measured Values via WAGO-I/O-CHECKPos : 93 /Serie 750 ( WAGO-I/O-SYST EM)/In Betrieb nehmen/Anzeig en der Mess wer te mi t WAGO-I/O-CH ECK 750-0493 @ 16\mod_1372771300798_21.doc x @ 125355 @ @ 1The measured values are displayed in the "3-phase power measurement" dialog inseveral views.The Overview view displays the measured values of all three phasescontinuously. These are:• Current, voltage Lx-N, active power, cos phi and frequency.An undervoltage is identified as a red square.Change of the Measuring Units!Specify the prefixes of the measuring units by selecting Home > Settings >Application. See section "Configuration with WAGO-I/O-CHECK" >"Application" Tab.The units can only be changed in the lists with the same physical variables. Forlists with different variables, base units are always used!Figure 23: Measured Values, Overview
