Wacker Neuson RS 800A Operator's Manual

RS 800 /... Operationwpm_tx001253gb.fm 214.7 To Start (RSS 800A)See Graphic: wc_gr0034724.7.1 Open the fuel valve by moving the lever to the right (a1).Note: If the engine is cold, move the choke lever to the closed position(b1). If the engine is hot, set the choke to the open position (b2).4.7.2 Open the throttle by moving it slightly to left (d2).4.7.3 Turn and hold the keyswitch in the “START” position (c2) to start theengine.DO NOT hold the keyswitch in the “START” position for more than fiveseconds. Damage to the starter may result.Note: If the engine does not start within five seconds, turn thekeyswitch to “OFF”, wait ten seconds, then turn the keyswitch to“START” again.4.7.4 When the engine starts, release the keyswitch and allow it to return tothe “ON” position (c1)4.7.5 Open the choke (b2) as the engine warms.4.7.6 Place the throttle in the full open position (d3) to operate.4.8 To Stop (RSS 800A)See Graphic: wc_gr0034724.8.1 Reduce the engine RPM to idle by moving the throttle lever completelyto right (d1).4.8.2 Turn the keyswitch to the “OFF” position (e2).4.8.3 Close the fuel valve by moving the lever to the left (a2).CAUTIONd1d2 wc_gr003472a2a1b1b2d1d3c3 c1 c2