Waldorf RN8410G Installation And Operation Manual

Also see for RN8410G: Installation and operation manual Installation and operation manual

Waldorf RN8410G Installation And Operation Manual Manual pdf 15 page image

13Oven Pilot Ignition1. Open the oven door. Depress the thermostat controlknob and rotate anti-clockwise to the ‘PILOT’ position.2. With the gas control knob depressed, press the piezoignition button to ignite the pilot burner. Repeat Items 1to 2 until the pilot is lit.3. Release the gas control knob approximately 10-20seconds after lighting the pilot, until the pilotthermocouple is heated up by the pilot flame.4. The pilot should now remain alight. If the pilot does notlight, repeat Items 1 to 3 above.5. View the pilot burner through the holes in the front ofthe burner box with the oven door open. See Fig 4.Oven - Main Burner / Thermostat1. With the pilot burner alight, rotate the thermostat control knob anti-clockwise to the desired oventemperature setting required, this will regulate the gas supply to the burner.2. To turn the main burner ‘OFF’, simply turn the thermostat control knob clockwise to the ‘OFF’position.Turning the Oven to ‘Standby’ (Pilot ‘ON’ Only)1. To turn off the oven burner / heating, set the oven thermostat to the ‘PILOT’ position, this will turnthe oven ‘OFF’, but leave the oven pilot burner ‘ON’.2. In this position the pilot burner will remain alight, but the main burner will not operate until thethermostat control knob is set to a temperature.3. If pre-heating of the oven is required, set the thermostat control knob to temperature 190°C andallow 20 minutes before cooking in the oven to allow the oven to warm up.Oven ‘Shut-Down’1. To turn the oven off to the ‘PILOT’ position only, rotate the thermostat control knob clockwise untilthe pilot position is reached. In this position only the pilot burner will remain on.2. To ‘Shut Down’ the oven, depress and turn the thermostat control knob to the ‘OFF’ position. Thiswill turn ‘OFF’ the oven and extinguish the pilot burner. To re-light the pilot burner, refer to ‘OvenPilot Ignition’ in this section.OperationPilot Burnerviewing holesFig 4! IMPORTANT DO NOT USE aluminium foil or trays directly on the cast iron sole plate(s).NEVER block or cover the openings on each side of the sole plate(s).Should any abnormal operation like;- ignition problems,- abnormal burner flame,- burner control problems,- partial or full loss of burner flame in normal operation, be noticed, the appliance requiresIMMEDIATE service by a qualified service person and should not be used until such service iscarried out.IMPORTANT