Waldorf RN8410G Installation And Operation Manual

Also see for RN8410G: Installation and operation manual Installation and operation manual

Waldorf RN8410G Installation And Operation Manual Manual pdf 9 page image

7Installation RequirementsNOTE:• It is most important that this appliance is installed correctly and that operation is correctbefore use. Installation shall comply with local gas and health and safety requirements.• This appliance shall be installed with sufficient ventilation to prevent the occurrence ofunacceptable concentrations of health harmful substances in the room, the appliance isinstalled in.Waldorf Ovens are designed to provide years of satisfactory service, and correct installation is essential toachieve the best performance, efficiency and trouble-free operation.This appliance must be installed in accordance with National installation codes and in addition, inaccordance with relevant National / Local codes covering gas and fire safety.AUSTRALIA: - AS5601 - Gas Installations.NEW ZEALAND: - NZS5261 - Gas Installation.UNITED KINGDOM: - Gas Safety (Installation & Use) Regulations 1998.- BS6173 - Installation of Catering Appliances.- BS5440 1 & 2 - Installation Flueing & Ventilation.IRELAND: - IS 820 - Non - Domestic Gas Installations.Installations must be carried out by authorised persons only. Failure to install equipment tothe relevant codes and manufacturer’s specifications shown in this section will void thewarranty.Components having adjustments protected (e.g. paint sealed) by the manufacturer are onlyallowed to be adjusted by an authorised service agent. They are not to be adjusted by theinstallation person.Unpacking• Remove all packaging and transit protection from the appliance including all protective plasticcoating from the exterior stainless steel panels.• Check equipment and parts for damage. Report any damage immediately to the carrier anddistributor.• Report any deficiencies to the distributor who supplied the appliance.• Check that the available gas and electrical supply is correct to that shown on the rating plate locatedon the front right hand corner of the bottom sill.Location1. Installation must allow for a sufficient flow of fresh air for the combustion air supply.2. Installation must include adequate ventilation means, to prevent dangerous build up of combustionproducts.3. Never directly connect a ventilation system to the appliance flue outlet.4. Position the appliance in its approximate working position.5. All air for burner combustion is supplied from underneath the appliance. The legs must always befitted and no obstructions placed on the underside or around the base of the appliance, asobstructions will cause incorrect operation and / or failure of the appliance.NOTE: Do not obstruct or block the appliances flue. Never directly connect a ventilation system tothe appliance flue outlet.InstallationCombustion Air Requirements:RN8410G RN8820GNatural Gas (G20) 32 m3 /hr 63 m3 /hrLPG / Propane (G31) 33 m3 /hr 65 m3 /hr