Waldorf RN8410G Installation And Operation Manual

Also see for RN8410G: Installation and operation manual Installation and operation manual

Waldorf RN8410G Installation And Operation Manual Manual pdf 23 page image

21Pilot Injectorsa. Unscrew and remove the Pilot Injector Plug from the fittingat the end of the pilot injector tube using a 11 mm A/Fspanner. (see Fig 23).b. Using a flat bladed screwdriver, unscrew and remove thepilot injector from the pilot injector housing.NOTE Take care not to lose the spring fitted in front of theinjector.c. Remove existing pilot injector and replace with the correctsize pilot injector for the gas type being used. Refer to the‘Gas Specifications’ table at the end of this section, forcorrect pilot injector sizes.d. Refit the spring and the correct pilot injector to the pilotinjector housing.e. Screw the pilot injector fully home using a flat bladescrewdriver and refit the pilot injector plug to the pilotinjector housing and tighten in place using a 11 mm A/Fspanner. (See Fig 23).f. Refit the splash guard over the gas cocks taking care not todamage the thermocouples and pilot burner tubes. Securein position with the 2 allan headed screws. (Note that thesplash guard for 'PF' models has a different cut-outs forpilot burner tubes. See Fig 24 & Fig 25).g. Refit the pilot burner tube shields over the pilot burnertubes / thermocouples and secure in place with the 2securing screws. (See Fig 21).h. Refit the burner caps and burner bowls onto the manifoldsprotruding through the splash guards. Take note that thebase part of the burner bowl has 2 locating holes drilledinto the base flange, (See Fig 17).these are to locate theburner bowl onto the allen headed screws that secure thesplash guard to the gas manifold. (See Fig 15).i. Refit all the trivet supports to the top of the appliance.Note the orientation of the trivet support when re-fitting asthe front end side rail profiles are different from the rearend side rail profiles. (See Fig 14).j. Refit the trivets to the top of the appliance taking note thatthe trivets are manufactured with a lip on one edge, the lipmust always be fitted to the outer edge (front and back) ofthe cook top. (see Fig 18).Low Fire Adjustmenta. To adjust the open burner low fire adjustment, remove thegas control knobs from the front of the control panel.b. Adjust the low fire adjustment screw on the open burnergas control valves to obtain the desired flame size. (Referto Fig 26).NOTE: The “Low Fire Screw” should be sealed with coloured paint on completion of the low fireadjustment.Gas Conversion and SpecificationsPilot InjectorPlugPilot InjectorHousingLow Fire Adjustment Screw Fig 26Fig 23Fig 24Cut-Out for PilotBurner &ThermocoupleFig 25Shown without PilotBurner Shield fitted.Pilot BurnerThermocouple