WaterLogic WL400 Series Manual

WL400 Manual Page 4 – Revision: 10-23-2019SAFETY ALERT SYMBOLSRead and follow all safety information carefully. The signal words used in this manual are selected asshown below and based on an assessment of the degree of potential injury or damage (severe orminor) and the occurrence of injury (definitely occurs or has the potential to occur) when thewarning is ignored:DANGER!Indicates a situation which, when not avoided, results in death or severe injury.WARNING!Indicates a situation which, when not avoided, has the potential to result in death or severeinjury; and/or severe property damage.CAUTION!Indicates a situation which, when not avoided, results or has the potential to result in minorinjury; and/or minor property damage.SAFETY PRECAUTIONSBasic safety precautions should be followed, including the following:Ensure all local, state, and federal laws and codes including health and safety guidelines are metwhen installing Waterlogic Equipment. Only qualified service technicians should attemptinstallation and service of Waterlogic Equipment. Always read the entire operating instructionsbefore using the appliance and save these instructions for future use.DANGER! ELECTRICAL SHOCK HAZARD. Always use a dedicated and properly grounded outlet.Unit should be protected by ground-fault circuit interrupter (GFCI) or residual current device (RCD)having a rated residual operating current not exceeding 30mA. Use only Waterlogic suppliedpower cord. Never use extension cords or power strips to connect unit. Do not use if the powersupply cord is damaged. Always unplug from power supply prior to servicing.WARNING! AUTHORIZED USE ONLY. This appliance is to be used for its intended purpose asdescribed in this manual and untrained individuals who use this manual assume the risk of anyresulting property damage or personal injury. This appliance can’t be used by children and personswith reduced physical, sensory or mental capabilities or lack of experience.WARNING! DO NOT OPERATE IF DAMAGED. Unplug if abnormal case occurs. Contact Waterlogicor authorized dealer for repair, service, and installation to avoid hazards.WARNING! HOT WATER. Unit produces Hot Water in excess of 87°C (188°F). Water above 52°C(125°F) can cause severe burns or scalding. Keep unauthorized people and children away from theunit to avoid accidental dispensing of hot water.