WaterLogic WL400 Series Manual

WL400 Manual Page 74 – Revision: 10-23-20199. Water does not dispense from UnitPossible Reason SolutionClosed water supply valve Open the water supply valve.The unit is not properlyplugged into electrical outlet Check electrical outlet connection, or for blown circuit breaker.Green Heater and CompressorSwitch button on unit is in theoff positionTurn Green Heater / Compressor Switch on.I = ON15 Amp Fuse Blown Replace the 15 Amp Fuse as needed.Water is present in the bottomtray, causing the leakdetection to trigger.Remove the top cover and front panel. Tip the unit slightly to drain,dry bottom tray completely.Hot and Cold Solenoidconnections into the DisplacePCB are loose.Turn power off; unplug the unit and visually inspect solenoidconnections into the Display PCB. Verify the soldering points onconnections are secure into the board.Remove the PCB to inspect the front of the board.Exhausted Filter Replace filters as needed.