Designer Series 2 w/ Optional BroilerInstallation and Operation ManualPG 18 OF 24M0079�07 OCTOBER 2017An ongoing program of product improvement mayrequire us to change specifications without notice.WOOD STONE CORPORATION1801 W. Bakerview Rd.Bellingham, WA 98226 USATOLL FREE 800.988.8103TEL 360.650.1111FAX 360.650.1166E-MAIL info@woodstone-corp.comwoodstone-corp.comLIGHTING THE BROILEROPTIONAL BROILER LIGHTING INSTRUCTIONS4. To adjust flame height, depress BurnerControl Knob, turn to the flame heightdesired, then release�The “High” setting position�The “Low” setting position�5. To change between functions, pushin the knob, turn to selection, thenrelease�TO TURN BROILER ONNote: Unit must be off for 5 min� before starting�1. Depress the Gas ControlKnob, turn it to the PILOTposition, and continue tohold down while depressing& holding down the redIGNITION button�2. Keep red IGNITION buttondepressed until visuallyconfirming the pilot has lit,then release� The pilot isvisible looking through theViewing Glass�3. After the pilot is lit, keep theGas Control Knob depressedfor about1 minute so that pilotremains lit when knobreleased�TO TURN BROILER OFFPush in Gas Control Knob and turn toOFF position and release�BroilerIgnitionButtonBroilerControl PanelBroiler GasControl KnobOvenControllerFlame HeightControl KnobViewingglassThe broiler operates independently of the oven controls� Turningeither the oven Controller or the broiler ON or OFF has no effecton the other unit� You must turn off both units separately�If the broiler pilot goes out, wait five minutes before attempting torelight it� Do not attempt to relight the pilot if you smell gas� Turnoff the oven and broiler until the gas smell clears� If you suspecta problem with the oven or broiler, contact your local distributorimmediately� Do not attempt to run the oven or the broiler untilthe problem is identified and corrected�TO ADJUST BROILER FLAME HEIGHT