Wood Stone vashon Installation And Operation Manual

Wood Stone vashon Installation And Operation Manual Manual pdf 9 page image

9an ongoing program of product improvement m ay require us to changespecications without notice. WS-IS-VA-CT, Revised July 2013 Info@woodstone-corp.com or visit woodstone-corp.comwood stone corporation1801 w. bakerview rd.bellingham, wa 98226 usatf. 800.988.8103t. 360.650.1111f. 360.650.1166Vashon Installation and Operation ManualUtIlItY connectIonsGas connectIonthe gas connection located at the back of the oven is a 3/8" npt schedule 40 nipple� to make installation easier, use a listedflexible connector and a readily accessible manual shut-off valve� Make the gas connection in accordance with all applicable localand/or national codes�Do not Use thIs aPPlIance If anY Gas leaKaGe Is DetecteD.The installation must conform with local codes, or in the absence of local codes with the National Fuel Gas Code, ANSI223.1 or Natural Gas Installation Code, CAN/CGA-B149.1, as applicable.The appliance and its individual shutoff valve must be disconnected from the gas supply piping system during anypressure testing of that system at test pressures in excess of 1/2 psi. The appliance must be isolated from the gas supplypiping system by closing its individual manual shutoff valve during any pressure testing of the gas supply system at testpressures equal to or less than 1/2 psi.The incoming gas supply pressure must not exceed 1/2 psi (14 inches WC). If the incoming gas pressure exceeds 1/2psi, an external gas regulator must be installed in the supply line. If the supply pressure is less than 1/2 psi, no externalregulator is required.The installer should bleed any air out of the gas line supplying the oven. All gas connections and fittings on the ovenshould be leak checked with an approved soap solution.electRIcal connectIonThis appliance must be electrically grounded in accordance with local code, or in the absence of local code, with thenational electrical code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.2, as applicable.This appliance is provided with a permanently attached power supply cord (2 wire plus ground) equipped with a NEMAType 6-50P plug. This must be attached to a NEMA Type 6-50R receptacle wired to either a 208 or 240 VAC single phaseindividual branch circuit rated at 40 A.ElectricalplugGas inletFlue gasoutletAir intakeInstallatIon1. turn off gas supply before starting installation�it is not necessary to remove the back panel to connect theoven to the gas supply system�2. use joint compound/thread sealant, and carefully connect thegas supply piping�3. check carefully for gas leaks immediately after theconnections have been made and the gas supply has beenturned on� use an approved leak test solution to check allflanges, joints and pipe connections� absolutely no gasleakage should occur—otherwise there is a danger of fire orexplosion depending upon conditions�please note you may notice a distinctive smell (hot insulation)upon initial start-up, but it will quickly dissipate�