XDrum DD 650 User Manual

Contents

XDrum DD 650 User Manual Manual pdf 20 page image

TOM1 ADVHeadroom 87TOM1 ADVSenseTime 50TOM1 ADVTrigger LinearADVANCED SETTINGSIncludes all the physical settings for pads/triggers.- Sensitivity: The higher the value is, the easier it will be totrigger. But if this value is too high, will cause some crosstalkproblems.- Headroom: Set the velocity dynamic range. This value isthe velocity needed to get max volume, so the lower thevalue is, the easier to get louder sounds.TIP: You can use the faders to adjust the volumequickly, but it will not be saved if you power off the soundmodule. The concept of Headroom is essentiallydifferent from Volume. Headroom decides the velocity toreach the max volume, but cannot change the max level ofvolume.- SenseTime: Sets the interval between two triggering. In-crease this value by certain amount may avoid being trig-gered multiple times by vibration in very short time.- Trigger: Sets the velocity curve for pads, including Linear,EXP1&2, LOG1&2 and Spline. On horizontal is the velocityyou strike, and on vertical is the volume after processed bythe trigger curve.TOM1 ADVSensitivity 77SETUPADVANCE [ENTER]V o l -umeV o l -umeV o l -umeV o l -umeLinear Exp Log SplineStrength StrengthStrength StrengthDiagram of 4 types of the velocity curveSETUP16TOM1 ADVNote Send 48- Xtalk: Sets the crosstalk for pads. Use max power to strikea pad repeatedly until the screen shows OK, and then changeto another pad and repeat the procedure. Velocity data onother pads will be loaded automatically for reference in orderto avoid crosstalk.- Note Send: Set the MIDI note for each trigger. When themidi note is different between this module and other soundsources, by adjusting this value they can be easily matched.TOM1 ADVXtalk Auto