693.2 Communication Parameter Setup (Printer Control Panel, 6030/6050)3.2 Communication Parameter Setup(Printer Control Panel, 6030/6050)This section explains the procedures for setting up the communicationparameters from the printer control panel.Procedure1 Press the < > key with [PORT SETTING]displayed.2 Select the interface that is to be set up withthe use of the < > and < > keys, andthen press the < > key.[TCP/IP], [SERIAL], [CENTRO], and [VPI]will be displayed, in that order.3 Select the parameters with the use of the< > and < > keys, and then press the key.An asterisk [*] will be displayed on the rightside of the value once it has been set up.4 After setting up all of the parameters, switchthe printer power off and then on for thechanges to take effect.TCP/IP SetupSNMP must be set up from Print Services on Web.The changed parameters become valid after the machine is rebooted.[CENTRO] and [VPI] are optional.The changed parameters are savedto the system when the key ispressed. It is not necessary to saveeach change individually.Refer to the previous section fordetailed information about each ofthe communication parameters.MENUPORT SETTINGPORT SETTINGTCP/IPTCP/IPEthernet SettingEthernet SettingAUTO *