Participant Guide Xerox 6204 Wide Format Solution20Activity 3 – Stopping a Copy Job using Refer to 3 Copy – Stopping Scanning & Copying in the UserGuide as you perform the activity.In this activity you will set up and start a copy job, then stop the jobwhile it processes.1. With the [Basic Copy] tab displayed, make the followingsettings:Reduce/Enlarge: AutoMedia Source: AutoMedia Type: Bond2. Verify that the Original Type selection on the [Image Quality]tab is set to Text/Line.3. Press 4 on the numeric keypad to set the copy quantity to 4.4. Feed the 24” x 36” original into the scanner SEF (portrait).5. Press the Stop button when the original is half done scanning.Scanning will stop with the original still in the DocumentHandler and the [Document Jam] screen will display. The 6204Wide Format automatically cancels the copy job because thescan failed to complete.6. Remove the Document Handler by pulling it toward the front ofthe machine and then lifting it up.7. Remove the original and set it aside.8. Reinstall the Document Handler on the machine. The [Ready toCopy] screen will appear and the quantity will remain set at 4.9. Feed the 24” x 36” original into the scanner again, SEF.10. Allow the document to scan completely.11. Press the Clear All button as soon as the first copy begins toexit the printer.The [Print Status] screen will display.12. Press the Stop button on the [Print Status] screen.The [Print – Delete Job] screen will display.13. Select the OK button.The job will stop and be canceled after the copies that are stillin progress complete their processing.14. Press Clear All.Activity 3 – Stopping a Copy Job using 1. Using the same job settings as before, including the copyquantity of 4, repeat steps 9 and 10 above. This time, however,stop the job using the button.2. Follow the procedure Method 2: Pressing the Status> button in the User Guide to stop and delete the copyjob.
