Xerox 665 User Manual

Also see for 665: System administrator guide Software guide Release note

Contents

Machine OverviewWorkCentre Pro 665/685/765/785 3-13 Machine OverviewThis chapter provides an overview of the WorkCentre’s hardwarefeatures and operation. The Control Panel is discussed and each keyis defined.System OverviewThe WorkCentre allows the user to send, receive, copy, and printdocuments. The ControlCentre software allows you to program theFax settings on a PC and write the settings to the WorkCentre.When you switch on the power and the system has warmed up, themachine is in the standby, or idle mode and is ready to use. When anaction completes successfully, the machine returns to the StandbyMode and displays the following information:Through the Menu mode, you can configure the standard machinesettings or customize your machine. Refer to Chapter 4 “GettingStarted” for basic programming instructions and procedures forsetting the standard machine settings.For optimum performance, the machine should be left on 24 hours aday. While the machine is powered on, the internal batteries arecharged.The primary battery retains the programmed data for up to 5 years ifthe machine loses power. Document data stored in a machine withstandard memory is retained for up to 72 hours during a power failureor power off, where the image battery is fully charged for more than 8hours prior to power off.12-01-1999 06:57ReadyFree memory: 100%Load document