Xerox 850DP - Phaser Color Solid Ink Printer User Manual

Also see for 850DP - Phaser Color Solid Ink Printer: Specifications Operator's manual Operator's manual System introduction Operator's manual

Contents

Xerox 850DP - Phaser Color Solid Ink Printer User Manual Manual pdf 27 page image

Web Print Manager Tool User Guide Page 27Ports MenuNavigation: PRINTER DEFAULTS > PORTSIf you entered the printer password in the Session Setup, you can change the followingparameters of the non-networked host communication ports and the Host Port Timeout.1. Host Port Timeout - This timeout value applies to the Controller’s centronics(parallel), and serial ports. If there is a pause in the incoming data stream over one ofthese ports, for the period of time specified here as the "timeout" value, the incomingplot data will be considered complete. Subsequent incoming data will begin a new plot.Valid values range from 5 to 300 seconds, with a factory default of 5 seconds.2. VPI timeout enabled - Selecting this option (by placing a checkmark in the box),causes the Host Port Timeout to also apply to the VPI port, if present on your AccXESController. If not selected (with the box not checked), then the VPI port will not time outwhile waiting for plot data.3. SCSIü SCSI Port ID - Click on this list box to select the value of the host interface targetSCSI ID. The range of possible values is from 0 to 7.ü SCSI Bus Termination - If the printer is the last device on the SCSI bus, click onthis list box and select Enabled. This will enable SCSI bus termination within theprinter.4. Serial Portü Baud Rate - Click on this list box to select the baud rate on the printer's serial port.The possible values are 300, 600, 1200, 2400, 4800, 9600 and 19200.ü Flow Control - Click on this list box to set the flow control to NONE, XON/XOFF,RTS/CTS, or BOTH. RTS/CTS corresponds to hardware control and XON/XOFF tosoftware control.ü Parity - Click on this list box to set the parity to EVEN, ODD or NONE.5. Press the Update Printer button to update the requested parameter changes in theprinter.NOTE: Changes made here only change the serial port settings on the printer (and not yourcomputer).