Xerox 850DP - Phaser Color Solid Ink Printer User Manual

Also see for 850DP - Phaser Color Solid Ink Printer: Specifications Operator's manual Operator's manual System introduction Operator's manual

Contents

Xerox 850DP - Phaser Color Solid Ink Printer User Manual Manual pdf 30 page image

Page 30 Web Print Manager Tool User Guide4. Ethernet TCP/IP Address - These four fields contain the IP address of the NetworkInterface Card on the printer’s AccXES Controller. The address is of the form "w.x.y.z"where the range for w, x, and y is 0-255 and z is 0-254.5. Ethernet TCP/IP Gateway - These fields contain the IP address of the device the printerwill use as the gateway or router. The format is the same as the Ethernet TCP/IPAddress.For the WIDE FORMAT PRINT SYSTEMS 8855, 721P, and X2 TECH, BEFORE pressingthe Update Printer button, click on the indicated hypertext link to save a TCP/IP Recoveryfile. If the Web PMT becomes unusable, you can send this recovery file to the AccXESController through the serial or parallel port. For the WIDE FORMAT PRINT SYSTEMS8825/8830/8850/ 510DP Printers, you MUST make a written record of these settingsBEFORE clicking the Update Printer button.NOTE: After modifying the IP Address, Subnet Mask, or Gateway, you should reboot (poweroff, then power on) the AccXES Controller to use the new settings.IPX/SPX Page (8830/8825 only)Navigation: PRINTER DEFAULTS > NETWORK > IPX/SPXIf you entered the printer password in the Session Setup, you can change the NovellIPX/SPX parameters in the printer if you have the network interface card. These parametersare described below:1. Enabled - Click on this check box to enable/disable IPX/NDS on the printer.2. IPX Frame Type - Click on this list box to select the IPX frame (link level) protocol.The possible values are AUTO, 802.3, 802.2, SNAP and ETHERNET2.3. IPX Queue Scan Rate - Enter the query interval in integer seconds (0-255). Thiscontrols the frequency with which NetWare file servers are queried for print jobs.4. Bindery Mode (Novell 3.XX) - Click on this radio button to enable the Bindery Mode;the NDS Mode will be disabled.IPX Primary Server - Enter the name (up to 47 characters) of a preferred server (in aNovell network). This server should hold the Novell network configuration file for theNetwork Interface Card (NIC), and will be the first server searched when the NIC bootsup with the printer. If this field is blank, all servers will be searched.NOTE: This field cannot be blank if the Bindery Mode is currently being used. Onpower-up, the NIC will search the network for the primary server that contains theconfiguration file that identifies all the available print servers. This text box will beignored if the NDS Mode radio button is selected (see below).5. NDS Mode (Novell 4.XX) - Click on this radio button to enable the NDS Mode; theBindery Mode will be disabled. The NDS Mode text boxes will be ignored if the NDSMode radio button has not been selected.ü IPX NDS Tree - Enter the name (up to 63 characters) of the NDS Tree to which theNIC connects.