Xerox 8850 Operator's Manual

Also see for Synergix 8850: User guide Setup guide User guide Release note Release note

Xerox 8850 Operator's Manual Manual pdf 24 page image

MEDIA14 XES SYNERGIX 8850 PRINTER OPERATOR MANUALChanging the roll media size and typeWhenever you open a media drawer, the message displayprompts you to change the type or width of the media. If you havenot changed the type or width of the roll media in the drawer, pressthe Exit key. If you have changed the type or width, you mustenter the new information.To change the roll media size and type:1. Press the Media key. The message display indicates thewidth and type of roll media last specified for drawer 1.NOTE: The Media key is active from either on-line or off-linemode.2. Press the Previous or Next key to scroll through the mediasource selections. The selections are ROLL1, ROLL2,ROLL3, and BYPASS SHELF (cut sheet feed-in shelf).3. When you scroll to the media source you want to change,press the Enter key. The message display instructs you toselect the media width. It indicates the current media width.NOTE: Media width does not apply to the BYPASS SHELFselection. If you have selected BYPASS SHELF as the mediasource, the message display instructs you to select the mediatype. Proceed to step 6.4. Press the Previous or Next key to scroll through the mediawidth selections. The width selections are:11.0 INCH 297 MM.12.0 INCH 353 MM.17.0 INCH 420 MM.18.0 INCH 500 MM.22.0 INCH 594 MM.24.0 INCH 620 MM.30.0 INCH 707 MM.34.0 INCH 750 MM.36.0 INCH 841 MM.860 MM.880 MM.900 MM.5. When you scroll to the desired media width, press the Enterkey. The message display instructs you to select the mediatype. It indicates the current media type.