Xerox 8850 Operator's Manual

Also see for Synergix 8850: User guide Setup guide User guide Release note Release note

Xerox 8850 Operator's Manual Manual pdf 52 page image

PROBLEM SOLVING42 XES SYNERGIX 8850 PRINTER OPERATOR MANUALStatus codesThe status codes shown in the table below may appear on themessage display. Follow the instructions in the table before callingfor service.Table 2. Status code tableStatus code ExplanationC0.-- This code indicates a cutter problem. Follow the instructions on the message display.C1.-- This code indicates a problem with roll 1. Follow the instructions on the message display.C2.-- This code indicates a problem with roll 2. Follow the instructions on the message display.C3.-- This code indicates a problem with roll 3. Follow the instructions on the message display.C4.-- This code indicates a problem at the cut sheet feed-in shelf. Follow the instructions onthe message display.E2.-- This code indicates a problem in the paper path. Follow the instructions on the messagedisplay.E4.-- This code indicates a problem in the fuser area. Follow the instructions on the messagedisplay.E5.-- This code indicates an interlock problem. Follow the instructions on the message display.E6.-- This code indicates a problem in the paper path. Follow the instructions on the messagedisplay.E7.-- This code indicates a communication failure with the AccXES controller. Switch theprinter and controller off. Wait a few seconds. Then switch the controller and printer on.E9.-- Switch the printer off. Wait a few seconds. Then switch the printer on.F1.-- This code indicates a problem in the finisher. Follow the instructions on the messagedisplay.F2.-- This code indicates a problem in the finisher. Follow the instructions on the messagedisplay.J1.01 This code indicates that the toner cartridge should be replaced. Refer to the "Replacingthe toner cartridge" section of this manual.J2.02 This code indicates that the toner cartridge is not installed correctly. Refer to the"Replacing the toner cartridge" section of this manual.LL.-- Switch the printer off. Wait several seconds. Then switch the printer on.