Xerox 8850 Operator's Manual

Also see for Synergix 8850: User guide Setup guide User guide Release note Release note

Xerox 8850 Operator's Manual Manual pdf 34 page image

OFF-LINE SETUP MENU24 XES SYNERGIX 8850 PRINTER OPERATOR MANUALSpecifying the finisher configuration typeTo specify the finisher configuration type:1. Access the PRINTER MENU. See "Accessing the PrinterMenu" in this chapter.2. Press the Previous or Next key until FINISHER SETTINGS isdisplayed.3. Press the Enter key to select FINISHER SETTINGS.4. Press the Enter key to select FINISHER CONFIG TYPE. Thecurrent value for the FINISHER CONFIG TYPE option isdisplayed.5. Press the Previous or Next key to switch between NONE and003.6. Press the Enter key to save your selection.7. Press the On-line/Off-line key to return to on-line mode.• The on-line/off-line indicator will light.• The display will indicate "XES SYNERGIX 8850 IDLE."Performing printer diagnosticsThe DIAGNOSTICS option has two operator-accessible sub-options – TEST PLOT and RECENT FAULT LOG.NOTE: A third DIAGNOSTICS option, PRINTER DIAGNOSTICS,is restricted to the service representative. If you select it, you willbe asked to enter a password. Press the Exit key to exit theoption.Printing a test plotTo print a test plot:1. Access the PRINTER MENU. See "Accessing the PrinterMenu" in this chapter.2. Press the Previous or Next key until DIAGNOSTICS isdisplayed.3. Press the Enter key to select DIAGNOSTICS.4. Press the Enter key to select TEST PLOT.5. Press the Previous or Next key to scroll through the mediasources.6. Press the Enter key to select the media source. The printerwill initialize the media supply and print the test plot.7. Press the On-line/Off-line key to return to on-line mode.• The on-line/off-line indicator will light.• The display will indicate "XES SYNERGIX 8850 IDLE."