Xerox 8850 System Introduction

Also see for Synergix 8825: User guide Setup guide User guide Release note Supplementary guide

Contents

Xerox 8850 System Introduction Manual pdf 23 page image

XES Synergix 8825/8830/8850/8855 & X2-TECH System Introduction 15Quick Start for DocumentCopyingNOTE: Copying is not currently supported by the X2-TECH system.• Make sure that media is loaded into all drawers of the XES Synergix8825, 8830, 8850, or 8855 Printer.For full details on loading the roll media, go to the 8825/8830/8850 or8855 Printer Operator Manual.• 8825/8830/8850 Digital Solution: If necessary, power on theScanner/Controller Circuit Breaker/Printer. (The Scanner MUST bepowered on first to be recognized.)• 8855 Digital Solution: If necessary, power on theScanner/Controller/Printer. The Scanner MUST be powered on first to berecognized.)• After initial power up, if the Scanner Control Panel prompts you for yourUser ID and Account ID, enter the alphanumeric Identifications suppliedto you by your System Administrator.• If your system was already powered up, you may have to press the Modekey to display "Ready To Copy." When the Scanner Control Paneldisplays "Ready To Copy," press the C/CA key on the Control Panel'skeypad to be certain that all settings are at their factory default values.Note: To modify settings, refer to the XES Synergix & X2-TECH DigitalSolution User Guide.• Insert your original document face down and centered on the feed tray ofthe Scanner.• Gently move your document forward until the Scanner’s feed rolls engagethe document’s leading edge.• As your document is automatically fed into the Scanner the resultingimage will be sent to the printer and your copy will be automaticallyprinted.NOTE: You may have to press the Start button if the configuration (forAuto Scan) has been changed from the factory default. For full details onScanner Configuration, refer to the XES Synergix & X2-TECH DigitalSolution User Guide.• When your document is returned to the ready position, lift the ThickDocument lever on the far right hand corner of the Scanner to removeyour document.NOTE: Your document may be fed out of the rear of the Scanner if theconfiguration (for Document Return) has been changed from the factorydefault. For full details on Scanner Configuration, refer to the XESSynergix & X2-TECH Digital Solution User Guide.• If you entered a User ID and Account ID when using the Scanner, besure to press the Exit key to log out of the system.Figure 8. Keys of the Scanner Control PanelSets BuildBatch SampleStore/RecallFinisherPrinterInterruptTransformStartStopREADY TO COPYINSERT DOCUMENTAUTO 100.0%Menu Exit ModeNext EnterPreviousABCC/CATUVWXYZDEFGHIJKLMNOPQRS970864 531 2.