Configuration of E-mail89Using Scan Service11Configuration of E-mailPreparationsPrepare the following to use the E-mail feature on the machine.z Registering E-mail accountAn E-mail account for the machine needs to be registered to a mail server.Note • Information about mail account registration, contact your system administrator.Installation OverviewThis section describes the configuration procedure to use E-mail on the machine.The following is the procedure to use E-mail.z Enabling Port and Setting TCP/IPEnable the mail send port and mail receive port, and set an IP address of themachine.z Configuring E-mail EnvironmentSet items for E-mail on the machine.Enabling Port and Setting TCP/IPThe following describes the configuration procedure to use TCP/IP on the machine.Enable the mail send port and mail receive port, and set an IP address of the machine.Note • The configuration can also be performed using CentreWare Internet Services orCentreWare Utilities.For information how to use CentreWare Internet Services, refer to "Using CentreWare InternetServices" (P.53).1 Display the [System Administrator Menu] screen.1) Press the button.2) Enter the UserID with the numeric keypad or a keyboard displayed by pressing[Keyboard], and select [Confirm].Note • The default UserID is “11111”. When using the Authentication feature, a password isrequired. The default password is “x-admin”.3) Select [System Settings].2 Enable the ports which are used for E-mail.1) Select [System Settings].2) Select [Network Settings].3) Select [Port Settings].4) Select [Send E-mail] and then select [Change Settings].5) Select [Port Status] and select [Change Settings].6) Select [Enabled] then select [Save].7) Select [Exit].8) Enable the [Port Status] in [Receive R-mail] as above.