Xerox ApeosPort C6550 I Network Administrator's Manual

11 Using Scan Service90Using Scan Service119) Select [Close] repeatedly until the [Network Settings] screen is displayed.3 Set an IP address.If an IP address is already set, this step is not necessary. Also, in an environment withDHCP or BOOTP, configure the way to obtain an IP address. Either the addresscannot be obtained automatically or manual configuration is preferred, configure an IPaddress, a subnet mask, and a gateway address.1) Select [Protocol Settings].2) Select [TCP/IP - Get IP Address] and then select [Change Settings].3) Select one from [DHCP], [BOOTP], [RARP], [DHCP/Autonet] or [Manual]. If youselect anything other than [Manual], proceed to step 4.Note • When using a DHCP server, also configure the WINS (Windows Internet Name Service)server.4) Select [TCP/IP - IP Address] and select [Change Settings].5) Select [TCP/IP - Get IP Address] and then select [Change Settings].Note • Enter the address in the format “xxx.xxx.xxx.xxx”. The "xxx" should be a numeric value in therange from 0 to 255. However, 224 or 225.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot be used.• When you make an entry mistake, press the (Clear) button and enter again.• When moving to the next value without entering all 3 digits, select [save/select next].6) Select [Save].7) Configure [TCP/IP - Subnet Mask] and [TCP/IP - Gateway Address] as the above.Note • Enter the address in the format “xxx.xxx.xxx.xxx”. The "xxx" should be a numeric value in therange from 0 to 255. However, 224 or 225.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot be used.• Specify the subnet mask by a combination of the numbers 0, 128, 192, 224, 240, 248, 252,254, and 255. However, you cannot use 0 between non-zero values.• If you do not set the gateway address, enter "0.0.0.0".4 Select [Close] repeatedly until the [System Settings] screen is displayed.5 Select [Exit].6 After the machine is restarted, print out a settings list to confirm that the mail send portis enabled and TCP/IP is configured.For information how to print a setting list, refer to “Print Report/List” in Chapter 12 of the User Guide.Configuring E-mail EnvironmentThe following describes the configuration procedure to use the E-mail feature.Note • The configuration can also be performed using CentreWare Internet Services orCentreWare Utilities.For information how to use CentreWare Internet Services, refer to "Using CentreWare InternetServices" (P.53).1 Display the [System Administrator Menu] screen.1) Press the button.2) Enter the UserID with the numeric keypad or a keyboard displayed by pressing[Keyboard], and select [Confirm].Note • The default UserID is “11111”. When using the Authentication feature, a password isrequired. The default password is “x-admin”.3) Select [System Settings].