iv WorkCentre C2424 Copier-PrinterMaintenance Safety■ Do not attempt any maintenance procedure that is not specifically described in thedocumentation supplied with your system.■ Do not use aerosol cleaners. The use of supplies that are not approved may cause poorperformance and could create a hazardous condition.■ Do not burn any consumables or routine maintenance items. For information on Xeroxsupplies recycling programs, go to www.xerox.com/gwa.Operational SafetyYour system and supplies were designed and tested to meet strict safety requirements. Theseinclude safety agency examination, approval, and compliance with established environmentalstandards.Your attention to the following safety guidelines helps to ensure the continued, safe operationof your system.System Supplies■ Use the supplies specifically designed for your system. The use of unsuitable materialsmay cause poor performance and a possible safety hazard.■ Follow all warnings and instructions marked on, or supplied with, the system, options andsupplies.CautionUse of other than Genuine Xerox WorkCentre C2424 Solid Ink may affect print and copyquality and system reliability. It is the only ink designed and manufactured under strictquality controls by Xerox for specific use with this system. The Xerox Warranty, ServiceAgreements, and Total Satisfaction Guarantee do not cover damage, malfunction, ordegradation of performance caused by use of non-Xerox supplies or consumables, or theuse of Xerox supplies not specified for this system.NoteThe Total Satisfaction Guarantee is available in the United States and Canada. Coveragemay vary outside these areas; please contact your local representative for details.Moving the SystemCautionParts of the system are hot. To avoid personal injury or damage to the system, allow the inkto solidify. Run the shut-down procedure to cool the system quickly. Wait at least30 minutes for the system to cool completely before moving or packing it.■ Always allow the system to cool before it is moved to avoid ink spills which can damagethe system.■ Use the shut-down procedure at the control panel Shut Down for Moving System forbest results.
