Tray 4 (Bypass)ColorQube™ 9301/9302/9303Paper and Media242Tray 4 (Bypass)Tray 4 (Bypass) is a paper tray on the left hand side of your device and can be folded away when not inuse. It is primarily intended for use as a small quantity, special materials feeder and accommodatesmedia of all types including transparencies, envelopes and tabs.When media is detected in Tray 4 (Bypass) a paper settings screen is displayed. The drop-down menusare used to change the size, type and color of the media loaded. The guides automatically detect thesize of media loaded and the device gives a warning if the guides are not set correctly or a non-standard media size is used. The following media can be loaded in Tray 4 (Bypass):• Up to 100 sheets of 75 gsm or 20 lb paper.• Weights from 60 to 216 gsm (16 to 56 lb).• Media sizes in the range A5 SEF to SRA3 SEF (5.5x8.5” SEF to 12x18” SEF). Envelopes sizes DL toC4 (#10 to 9x12”), all envelopes must be fed Short Edge Feed (SEF).• Media types:• Bond, standard or recycled paper• Card• Pre-printed media• Labels• Transparencies• Hole punched paper• Carbonless paper• Tabs• EnvelopesNote For 80 gsm paper capacities are slightly lower then specified.Loading Tray 4 (Bypass)Your device alerts you if Tray 4 (Bypass) is selected for a job and the media requested does not matchthe media currently loaded. It also warns you if the tray runs out of paper during a job.1. Make sure the tray is in the downposition. For larger media, use the trayextension.2. Place the media on the tray. Locatethe media to the right edge.• Load pre-printed paper andlabels face down and with thetop towards the front of thedevice.• Load hole punched paper withthe holes on the left.• Load transparencies face down with the white strip on the left.For information about loading tabs, refer to Pre-Cut Tabs on page 249.
