16 Problem Solving338 Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128/133 User GuideScreen MessagesAlong with fault codes, the following messages are displayed on the touch screen insome occasions.116-749 The print job was stopped because the specified font was not found. Install thefont or enable font replacement in the print driver.116-771116-772116-773116-774116-775116-776116-777116-778The parameter values were corrected because the machine encountered aproblem when printing the data. If the received image is incomplete ordamaged, ask the other party to check the image or to resend the data. WhenInternet Fax forwarding is enabled, check with the recipient if they received theimage intact.116-780 There is a problem with the document attached to the received e-mail. Checkthe attached document.124-701 Due to a malfunction in the specified tray, the output destination was changed tothe center output tray. Contact the Xerox Welcome Center. Use a differentpaper tray.Code Description and RemedyMessage Description and RemedyA fault has occurred.Switch off the machine. Ensure that thescreen disappears before switching it on.If the problem persists, call for service.A fault has occurred. Switch off the machineand wait until the touch screen is turned offcompletely, and then restart the machine. Ifthe problem persists, write down the faultcode (xxx-yyy) displayed on the screen.Switch off the machine and contact the XeroxWelcome Center.A fault has occurred. The machine hasrebooted. If the problem persists, call forservice.The machine was restarted due to a fault.Resume normal operations. If the problempersists, contact the Xerox Welcome Center.Processing has been cancelled due to anerror.See User Guide for information on fault code.The machine operation has stopped due to afault. Restart the job.
