Page 3 - 10 Xerox Document Centre Network Installation & Troubleshooting GuideWindows Internet Name Service (WINS) InstallationBefore You StartIf your printer is equipped with a Token Ring interface, use the100BaseT Ethernet or Token Ring Quick Install Card suppliedin this Quick Install Card set to configure the Ring Speed andSource Routing settings for your environment.Your Document Centre now has DHCP, LPR, and NetBIOS overthe IP protocol enabled by default. If your DHCP server willprovide the IP address, Gateway address, Subnet Mask for theDocument Centre, and WINS server address(es), the TCP/IPinformation will be configured on initial boot. This means that ifyou have configured your DHCP server with the desiredinformation, you may connect your Document Centre to yournetwork and it will boot and register with the WINS serverautomatically.NOTE: Your DHCP server must return at least one (1) WINS serveraddress to the Document Centre in order to enables WINSregistration.In this mode the default NetBIOS host name, SMB host name andthe DNS host name for the device will be the letters XRX followedby the MAC address of the network interface.Example:XRX08003E313E0AIf this NetBIOS host name is acceptable you can go right to thesection in the next section entitled Go to the Workstation and....and complete those steps.To change the NetBIOS host name for your printer follow Steps1,2, and 3 then skip to Step 5 and finish the Go to the Printer...portion. When you finish that section, go to the section entitled Goto the Workstation and.... and complete those steps.
