Xerox FaxCentre 2218 System Administration Manual

Also see for 2218 - FaxCentre B/W Laser: Voluntary product accessibility template User guide Quick reference Service manual Service manual

Contents

Xerox FaxCentre 2218 System Administration Manual Manual pdf 32 page image

Page 4-4 Xerox WorkCentre 4118 and FaxCentre 2218 System Administration GuidePrint Driver Installation for Networked Printers Windows XP (TCP/IP)NOTE: Windows XP supports printing via TCP/IP as standard when TCP/IP is installed on aWindows XP Workstation.Ensure you have the correct drivers CD (part number 705N00017 for PCL or 705N00021 forthe driver compatible with PostScript® 3TM ) prior to starting this procedure.Use the Add Printer Wizard to add the WorkCentre 4118 / FaxCentre 2218 to the network.¾ Select [Start], select [Printers and Faxes].Double-click on the [Add Printer] icon to display the Add Printer Wizard and select [Next].¾ Select [Local Printer attached to this computer], uncheck the box labelled [Automaticallydetect and install my Plug and Play printer] and then select [Next] to display the dialog boxlisting available ports.¾ Select [Create a new port].Select [Standard TCP/IP Port] and select [Next] to display the Add Standard TCP/IPPrinter Port dialog box and select [Next].Enter the IP Address of the printer in the [Name or address of printer] field (you canoptionally enter a friendly name for the printer port you are creating or use the defaultname created). Then select [Next] to continue.If the network printer settings are not automatically detected, click on the [Custom] buttonto setup the network printer port settings, then select [Finish].It is recommended that you select [RAW] as the Print Protocol.If you prefer to use LPR:Select [LPR] as the Print Protocol.Enter [lp] (in lower case) in the [LPR queue name] field.Uncheck the box labeled [LPR Byte Counting Enabled].Check the box labeled [SNMP Status Enabled].The [Community Name] should normally be set to public (unless you have configured thedevice to have a custom SNMP community name) and the [SNMP Device Index] shouldbe set to 1.Select [OK].¾ The Add Printer Wizard will then request that you select the driver to be used for thisprinter.1234