Maintenance and CleaningPhaser® 6115MFP Multifunction Product10-3Keep the following guidelines in mind:■ Be careful when cleaning the inside of the product or removing media misfeeds, as thefuser and other internal parts may be very hot.■ Do not place anything on top of the product.■ Use a soft cloth to clean the product.■ Never spray cleaning solutions directly on the product’s surface; the spray could penetratethrough the air vents of the product and damage the internal circuits.■ Avoid using abrasive or corrosive solutions or solutions that contain solvents (such asalcohol and benzene) to clean the product.■ Always test any cleaning solution (such as mild detergent) on a small inconspicuous areaof your product to check the solution’s performance.■ Never use sharp or rough implements, such as wire or plastic cleaning pads.■ Always close the product’s covers gently. Never subject the product to vibration.■ Do not leave the product’s covers open for any length of time, especially in well-lit places.Light exposure can damage the imaging unit.■ Do not open the product’s covers during printing.■ Do not lubricate or disassemble the product.■ Do not tilt the product while in use.■ Do not touch the electrical contacts, gears, or laser devices. Doing so may damage theproduct and cause the print quality to deteriorate.■ Keep media in the output bin at a minimum level. If the media is stocked too high, yourproduct may experience media misfeeds and excessive media curl.■ Make sure any parts removed during cleaning are replaced before you plug in the product.
