Xerox WORKCENTRE PE 220 Service Manual

Also see for WORKCENTRE PE 220: Service manual Service manual Service manual User guide Setup guide

Contents

Xerox WORKCENTRE PE 220 Service Manual Manual pdf 10 page image

Introductionviii 11/05 Workcentre PE 2208. Maintain continuous electrical contact between the ESD and the assembly into which it will beinstalled, until completely plugged or soldered into the circuit.9. Minimize bodily motions when handling unpackaged replacement ESDs. Normal motions, suchas the brushing together of clothing fabric and lifting one’s foot from a carpeted floor, can generatestatic electricity sufficient to damage an ESD.Super Capacitor or Lithium Battery Precautions1. Exercise caution when replacing a super capacitor or Lithium battery. There could be a dan-ger of explosion and subsequent operator injury and/or equipment damage if incorrectlyinstalled.2. Be sure to replace the battery with the same or equivalent type recommended by the manu-facturer.3. Super capacitor or Lithium batteries contain toxic substances and should not be opened,crushed, or burned for disposal.4. Dispose of used batteries according to the manufacturers instructions.Print Cartridge ServiceOnly print cartridges supplied by Xerox should be used. Printing defects or set damage caused bythe use of non-approved print cartridges or un-licensed toner refills are not covered by the guar-antee.Precautions on Safe-keeping of Print CartridgeExcessive exposure to direct light for more than a few minutes may cause damage to the car-tridge.Service for the Life of Print CartridgeIf the printed image is light due to the toner supply becoming low you can temporarily improve theprint quality by redistributing the toner (Shake the print cartridge), however you should replace theprint cartridge to solve the problem permanently.Redistributing TonerWhen the print cartridge is near the end of its life, white streaks or light print occurs. The LCD dis-plays the warning message, “Toner Low.” You can temporarily re-establish the print quality by re-distributing the remaining toner in the cartridge.Standard of guarantee for consumable parts.Please refer to User Manual or Instructions on Fax/Printer Consumables SVC manual for the cri-teria for judging the quality of consumable parts the standard of guarantee on those parts.• Spotting a refilled cartridge by eye.One way security screws are used in the manufacture of the cartridge – check if these are dam-aged.