Xerox WORKCENTRE PE 220 Service Manual

Also see for WORKCENTRE PE 220: Service manual Service manual Service manual User guide Setup guide

Contents

Xerox WORKCENTRE PE 220 Service Manual Manual pdf 149 page image

General Procedures and InformationWorkcentre PE 220 11/05 6-41GP 6 LCD Status Error MessagesTable 1:STATUS LCD Display DescriptionsDocument Jam Document Jam When Document Jam occurred at ADF module.Door Open or JamCover Open[Front or Rear][Cover Open]When machine’ front side cover or Jam Cover wasopened.NO paper [No Paper]Add PaperWhen there is no paper in CASSETTE Tray.PAPER JAM 0 [Paper Jam 0]Open/Close DoorWhen the machine encountered paper jam in pick uparea, Machine displays on the LCD until DOOR OPEN &CLOSE.PAPER JAM 1 [Paper Jam 1]Open/Close DoorWhen the machine encountered paper jam in paper exitof Machine, machine displays on the LCD until DOOROPEN & CLOSE.PAPER JAM 2 [Paper Jam 2]Check InsideWhen the machine encountered paper jam in paper exitof Machine, machine displays on the LCD until DOOROPEN & CLOSE.Communication Error [COMM. Error] When the machine has a problem in communication.Machine displays this in case of Transmission.Machine displays this in case of fax handshaking step ofReception.Line Error [Line Error] When the machine has problem in case of Fax Datareception step.NO ANSWER [No Answer] When the machine could not connect to remote fax afterCompletion of redial up to redial counter in system data.INCOMPATIBLE [Incompatible] Remote party did not have the requested feature, suchas polling.LINE BUSY Line Busy The remote fax did not answer.POWER FAILURE Power Failure When the machine user memory has not been backedup and there was power off / on.STOP PRESSED [Stop Pressed] When the operator pressed the STOP key during trans-mission.MEMORY FULL Memory Full When the machine has encountered the user memorywas full,FUSER ERROR CRU Fuse Error When the machine failed in installing the new print car-tridge.LSU ERROR [Hsync Error] Tech modeLSU ERROR [LSU Error] User modeThe LSU does not reach the READY state,TONER LOW [Toner Low] The machine has encountered the Toner Low,TONER EMPTY [Toner Empty] The machine has encountered the Toner Empty,BYPASS JAM [Bypass Jam] The machine detected the non feeding from BYPASSTray.GROUP is not available Group Not Available You have tried to select a group location where only asingle Location number can be used.RETRY REDIAL? Retry Redial? The machine is waiting for the programmed interval toautomatically redial a previously busy station.NO. NOT ASSIGNED NO. Not Assigned The speed dial location you tried to use has no numberassigned to it.