Xerox WorkCentre 5020 User Manual

Also see for WorkCentre 5016: Specification User guide

Contents

Xerox WorkCentre 5020 User Manual Manual pdf 44 page image

Loading Paper in the TraysXerox WorkCentre 5016/5020 User Guide442. Load paper neatly and tightly againstthe left corner of the tray with the sideto be printed facing up.Important • Do not load paper above themaximum fill line. It may causepaper jams or may lead to machinemalfunctions.• Do not add a new stack of paperon top of the remaining paper in thetray. Remove the remaining paperin the tray, put it together with anew stack of paper, align the edgesneatly, then load the stack of paperin the tray. This reduces the possibility of paper jams.3. Adjust the three paper guides to justtouch the edges of the paper, and alignthe arrow on the right paper guide withthe appropriate paper size marking onthe label.Important • If you do not adjust the paperguides correctly, it may result in apaper jam.Note • If loading a relatively thin stack ofpaper in the tray, when tightlyadjusting the right paper guide upagainst the edge of the paper, the stack of paper can be warped. This will not result in apaper jam as long as the paper guide arrow is correctly aligned with the appropriatepaper size marking on the label.4. Push in Tray 2 gently back into position.Loading Paper in the Bypass TrayWhen printing on paper that cannot be loaded into Tray 1 or Tray 2, such as non-standard size paper, use the Bypass Tray.The following procedure describes how to load paper in the Bypass Tray.Important • Do not load a new stack of paper until the remaining paper in the tray runs out completely.Alternatively, remove the remaining paper before loading a new stack of paper.Note • Before loading paper in the tray, fan the edges. This separates any sheets of paper that arestuck together, and reduces the possibility of paper jams.• When using non-standard size paper for a print job, you must register its paper size in theprint driver in advance.For information on how to specify a custom paper size in the print driver, refer to"Specifying the Custom Paper Size" (P.79).1. Open the Bypass Tray.