Regulatory InformationXerox ® WorkCentre® 6655/6655i Color Multifunction Printer 275User GuideNew Zealand1. The grant of a Telepermit for any item of terminal equipment indicates only that Telecom hasaccepted that the item complies with minimum conditions for connection to its network. It indicatesno endorsement of the product by Telecom, it does not provide any sort of warranty, and it does notimply that any Telepermitted product is compatible with all Telecom network services. Above all, itprovides no assurance that any item will work correctly in all respects with another item ofTelepermitted equipment of a different make or model.The equipment may not be capable of correct operation at the higher data speeds designated.33.6 kbps and 56 kbps connections are likely to be restricted to lower bit rates when connected tosome PSTN implementations. Telecom will accept no responsibility for difficulties that arise in suchcircumstances.2. Immediately disconnect this equipment should it become physically damaged, then arrange for itsdisposal or repair.3. This modem shall not be used in any manner which could constitute a nuisance to other Telecomcustomers.4. This device is equipped with pulse dialing, while the Telecom standard is DTMF tone dialing. There isno guarantee that Telecom lines will always continue to support pulse dialing.5. Use of pulse dialing, when this equipment is connected to the same line as other equipment, maygive rise to 'bell tinkle' or noise and cause a false answer condition. If you encounter such problems,do not contact the Telecom Faults Service.6. DTMF tones dialing is the preferred method because it is faster than pulse (decadic) dialing and isreadily available on almost all New Zealand telephone exchanges.WARNING: No '111' or other calls can be made from this device during a mains power failure.7. This equipment may not provide for the effective hand-over of a call to another device connectedto the same line.8. Some parameters required for compliance with Telecom Telepermit requirements are dependent onthe equipment (computer) associated with this device. The associated equipment shall be set tooperate within the following limits for compliance with Telecom Specifications:For repeat calls to the same number:− There shall be no more than 10 call attempts to the same number within any 30 minute periodfor any single manual call initiation, and− The equipment shall go on-hook for a period of not less than 30 seconds between the end ofone attempt and the beginning of the next attempt.For automatic calls to different numbers:The equipment shall be set to ensure that automatic calls to different numbers are spaced such thatthere is no less than five seconds between the end of one call attempt and the beginning ofanother.9. For correct operation, total of the RNs of all devices connected to a single line at any time shouldnot exceed five.
