Xilinx ZC702 Getting Started Manual

Also see for ZC702: Quick start guide Quick start guide Getting started guide User guide User guide

ZC702 and ZVIK Getting Started Guide www.xilinx.com 13UG926 (v3.0.1) February 12, 2013Default Jumper and Switch SettingsDefault Jumper and Switch SettingsFigure 1-3 calls out the major features on the ZC702 board. See UG850, ZC702 EvaluationBoard for the Zynq-7000 XC7Z020 All Programmable SoC User Guide for more detailedinformation about the ZC702 board.Default factory settings of jumpers and switches on the ZC702 board are highlighted inFigure 1-4. Default switch and jumper settings are listed in Table 1-1 and Table 1-2.X-Ref Target - Figure 1-3Figure 1-3: Feature Callout for the ZC702 BoardFMC1 LPCConnectorXilinx XADCHeaderUG926_c1_03_081412FMC2 LPCConnector8 User LEDsUser 2-Pole DIP SwitchZynq-7000 AP SoCPower Management System(Bottom and Top of Board)FPGA PROG PushbuttonI2C Real-time Clock (RTC)DDR3 ComponentMemory (1 GB)RGMII EthernetPHY Oscillator,25,000 MHzQuad SPI Flash Memory (1 Gb)SD Card Interface ConnectorConfiguration ModeSelect SwitchSystem Clock, 200 MHz,2.5V LVDSI2C Bus SwitchPower On/Off Slide SwitchCAN Bus TransceiverHDMI Controller,HDMI Video ConnectorUSB JTAGModule with IntegratedUSB Mini-B ConnectorI2C Programmable UserClock 3.3V LVDSUser PushbuttonsActive HighEthernet StatusLEDsUSB-to-UART Bridge,USB Mini-B Connector2x6 Male HeaderPins I/O Driven fromI2C Expander U80USB 2.0 ULPITransceiver,USB Micro-BConnector10/100/1000 MHzEthernet PHY,RJ45 with Magnetics2x6 and 1x6PMOD I/O Header