Xilinx ZC702 Getting Started Manual

Also see for ZC702: Quick start guide Quick start guide Getting started guide User guide User guide

Chapter 3: Getting Started with the Base Targeted Reference Design32 www.xilinx.com ZC702 and ZVIK Getting Started GuideUG926 (v3.0.1) February 12, 2013TRD Demonstration ProcedureThis section provides a procedure for setting up the ZC702 board or ZVIK and running thedemonstration provided with the kit.Board Setup1. For customers using the ZVIK, assemble the FMC module to the ZC702 base board. TheFMC module and HDMI video input are not required for either kit to run the TRD, butZVIK customers can run the TRD demonstration using the external video input inaddition to the built-in Test Pattern Generator if the FMC card is installed. Two sets ofstandoff hardware are in the box, which can be used to secure the FMC-IMAGEON FMCmodule on the ZC702 base board and support the free end of the board. Assemble thehardware as shown in Figure 3-3. Use the longer standoffs, screws, and rubber feet forthe free end of the board.2. Connect the cables as shown in Figure 3-2 to prepare the ZC702 board to run the TRDvideo demonstration.a. Connect an LCD monitor to the HDMI out port P1 of the ZC702 board using an HDMIcable.b. Connect a keyboard and mouse to the USB hub, which is connected to the ZC702board Micro-B USB connector J1 labeled USB ULPI through the USB Micro-B tofemale A adapter. If a USB hub is not available, the mouse can be plugged directlyinto the female USB connection of the USB Micro-B to female A adapter, but the userX-Ref Target - Figure 3-2Figure 3-2: ZC702 Board Setup for a Video DemonstrationKeyboard and mouseconnected through USB hubVideo-InPower UG926_c3_02_080712UART connectorJ1