Xilinx ZC702 Getting Started Manual
Also see for ZC702: Quick start guideQuick start guideGetting started guideUser guideUser guide
                                                    | |
Contents
|
ZC702 and ZVIK Getting Started Guide www.xilinx.com 19UG926 (v3.0.1) February 12, 2013Hardware Bring-UpHardware Bring-UpThis section describes the steps for hardware bring-up.1. Be sure to have the SW16 Mode switch settings set to those shown in Figure 2-1.2. With the ZC702 board switched OFF (SW11 in the down position, as shown inFigure 1-4), plug the USB Mini-B cable into the Mini USB port J17 labeled USB UART onthe ZC702 board and the other end into a open USB port on your PC (Figure 2-2).3. Connect the power cable.4. Switch the ZC702 board’s power to ON (SW11 switched up as shown in Figure 1-4).X-Ref Target - Figure 2-2Figure 2-2: ZC702 with the UART and Power Cable AttachedUG926_c2_02_080212USB/UART12V PowerInit LED |
Related manuals for Xilinx ZC702
Xilinx Virtex-4 FX12 Getting Started
Xilinx Virtex-7 FPGA VC7203 Characterization Kit IBERT Getting Started Manual
Xilinx MicroBlaze Spartan-3E 1600E Edition Getting Started
Xilinx MicroBlaze Spartan-3E 1600E Edition Getting Started
Xilinx Spartan 6 FPGA Quick Start Manual
Xilinx VCU110 Manual
Xilinx ML410 User Manual
Xilinx VCU1525 User Manual
Xilinx VCU1525 User Manual
Xilinx Virtex-5 LXT User Manual
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine